Digital Thermometer (DB18B20) TO-92  (datasheet) The dB18B20 is a pretty nifty digital thermometer that supports the 1-Wire interface.  It also supports 3.0V - 5.5V supply power so it easily fits in most microcontroller projects.  Although it's a bit more expensive than analog alternatives, the hardware setup is dead simple.
		Pin Headers (1x36), Right Angle  (datasheet) Standard .1" spacing pin headers with a right angle bend, and they're also breakaway.  Use it in combination with pin sockets for an easy way to add a secondary board to your project.
		SD Card Slot  (datasheet) SD is a easy way to add tons of storage to your design.  Adding this slot to our project boards requires a little finagling, but it's not hard.
		RGB LED, Common Anode  (datasheet) Most microcontrollers sink more than they source, so a common anode LED is easier to connect.  Our RGB LED has a 5mm diffused lens, a bit bigger and brighter than our other LED's.
		Rubber Feet, 4 Pack  (datasheet) An oft-requested inventory item, rubber feet keep the bottom of the board off the table and add a bit of finish to your project.  Do you really need to read the datasheet?
		Snap Switch, SPDT  (datasheet) We've had these switches for a little while - they're awesome!  One pin is common, the middle pin is normally open, and the third pin is normally closed.  It fits great on all of our boards and the action is a lot nicer than a typical tact. switch.

We're always adding items to our inventory. If you don't see what you need for your project, just drop us a line in the forums and we'll see what we can do. Also, designers can now order parts directly from us!

Get Parts »

Comments (0)

Subscribe to this comment's feed

Write comment

Email Name		Title Comment smaller | bigger
		Add Comment Preview